Drive Control

Externalpowered


  1. The DARVIN speaker is driven by PAX amplifiers, connected via 8 pol Speakon
       (optional 8 Pol CACOM).

    The PAX P16 amplifier provides sense drive for wide band damping factor
       correction.

    The optimum is to run two and at short cable length also three DARVIN parallel.

    With only one 8 U Pro-User-System-Case it is possible to run up to 6 DARVIN.

    A 12 pairs LK37 multi pin connector on the system patch bay connects the
       HEIMDALL D1 F.I.R./I.I.R. digital controller.

    It is possible to vary horizontal dispersion in certain frequency ranges by using
       different settings on the HEIMDALL D1 controller.

    The PAX P16 amps (with optional remote module) and the HEIMDALL D1
       controllers can be remote controlled via ethernet within one(!) software GUI.



Internalpowered


  1. The 4650 Watts rms internal amplifier (three channels each 1550 Wrms based on PAX
       P16) provides optimum fan free power for DARVIN.

    Thru a 3 pin and a 5 pin XLR connector the system is connected with the
       HEIMDALL D1 controller.

    The internal amplifiers are power supplied via power-con by a switch mode power supply.




Internal-powered systems guarantee greater performance and more dynamics, lower overall system cost, and extremely fast and secure setup.